{\rtf1\ansi\ansicpg1252\deff0\uc1{\fonttbl{\f0\fcharset0 Times New Roman;}}{\colortbl
;}{\stylesheet{\s0\nowidctlpar\nooverflow\sl240\slmult1\f0\fs20\kerning28 Normal
;}}\paperw12240\paperh15840\margt1440\margl1800\margr1800\margb1440\headery720\footery864
\deftab720\pgnstart1\viewkind1\viewscale100\fet0{\*\docvar{ColorSet}{-1}}{\*\docvar
{ColorPos}{-1}}{\*\docvar{StyleSet}{-1}}{\*\docvar{StylePos}{-1}}\pard\plain\pard\nowidctlpar\nooverflow\sl240\slmult1{\f0\lang1033\fs32\kerning28
{\header\pard\nowidctlpar\nooverflow\sl240\slmult1\tqc\tx4320\tqr\tx8640\fs20\par
}{\footer\pard\nowidctlpar\nooverflow\sl240\slmult1\tqc\tx4320\tqr\tx8640\fs20\par
}        REPORT ON THE DEATH OF  GISELLE IANURE\par}

\pard\nowidctlpar\nooverflow\sl240\slmult1{\f0\lang1033\fs32\kerning28         OCT
. 1{\super ST} 2005\par}

\pard\nowidctlpar\nooverflow\sl240\slmult1{\f0\lang1033\fs32\kerning28\par}

\pard\nowidctlpar\nooverflow\sl240\slmult1{\f0\lang1033\fs24\kerning28 1- Victim
    The victim was a 43 year old white female. Unmarried, with no nearby family.  
She was hired as a stand in for another actress while certain scenes were being 
shot in a movie about the French revolution. She had a background as a magician\u8217
\'92s assistant and as an actress herself. The magician she used to work with used
 as part of his act a guillotine which he used to apparently behead Miss Ianure.  
Because of this she quite used to being around and working with guillotines and 
with acting out the part of a condemned woman. \par}

\pard\nowidctlpar\nooverflow\sl240\slmult1{\f0\lang1033\fs24\kerning28 2- Scene      
When  I arrived on the scene I found a typical movie sound stage with lights, cameras
, background scenery, and the like. In the center of the set was what appeared to
 be a fully functional guillotine with the corpse of the victim still strapped onto
 the table. Her head was laying on the floor just in front of the device and there
 was an amount of blood that I estimate to be approximately five quarts pooled on
 the floor under her body. The blade was still in the position where it landed after
 severing the neck of the victim. There were many people around and most had witnessed
 the death. \par}

\pard\nowidctlpar\nooverflow\sl240\slmult1{\f0\lang1033\fs24\kerning28 3-  Statements
 and other evidence gathered at the scene.    The death was captured on digital 
videotape by two cameras  and there was another two and a half hours of tape showing
 Miss Ianure\u8217\'92s involvement with the guillotine just before her death. Statements
 and the tapes agree on all basic facts with only minor differences. The victim 
was being used to act the part of a French noblewoman being executed and the scene
 being filmed was the execution. She was led in bound and was strapped onto the 
table of the guillotine. Then the table was lowered and her head placed in the lunette
 under the raised blade. The guillotine had built into it a stop pin designed to
 stop the fall of the blade about two inches before it could strike the neck of 
anyone in the path of the blade\u8217\'92s fall. during the filming the blade was
 dropped twenty three [23] times with the stop pin working perfectly each time. 
On the twenty fourth [24{\super th}] time the pin failed and the blade beheaded 
Miss Ianure. Death occurred within seconds. \par}

\pard\nowidctlpar\nooverflow\sl240\slmult1{\f0\lang1033\fs24\kerning28 4-   Examination
 of the guillotine and its use     The device was a fully functional guillotine 
with the only change to the basic classical design was the inclusion of a brass 
pin that was installed in the left slide rail. This pin\u8217\'92s function was 
to stop the fall of the blade. Brass was chosen for three major reasons, the first
 of which was it matched the brass rivets used in the construction on the device
, second brass would not harm or deform the steel blade, and last it was much quieter
 that a steel pin would have been on impact. That the pin might fail had been considered
 and several new pins were on hand. There was a standing requirement for the person
 responsible for maintaining the device to examine it before each use and to replace
 the pin if it showed any  signs of damage or deformation. It had been replaced 
that morning and since there had never been any problems with it during a day\u8217
\'92s shooting it was not checked again. There were somewhere between thirty [30
] and thirty three [33]  uses of the stop pin before it failed. No one present could
 remember any time where there had been so many drops in one day before. \par}

\pard\nowidctlpar\nooverflow\sl240\slmult1{\f0\lang1033\fs24\kerning28 5-   Post
 Mortem findings   The body  was clad in a dirty sleeveless shift that was about
 knee length. There were no other clothes on the body.  At first glance it appeared
 to be dirty and bruised but upon closer examination both the dirt and the bruises
 were makeup. \par}

\pard\nowidctlpar\nooverflow\sl240\slmult1{\f0\lang1033\fs24\kerning28 The body 
was as one would expect of a female of her age but in perhaps better physical condition
. There were no remarkable defects nor abnormalities. She was healthy, well fed 
but slender, not a virgin and not pregnant. In fact the only thing notable about
 the body was signs of extreme engorgement of the vaginal lips and a large amount
 of wetting of the type caused by sexual arousal. In my opinion at the time of her
 death Miss Ianure was very much sexually aroused.   The cut line was very clean
 and straight and there were no signs of struggle or force. The body was almost 
completely drained of blood. \par}

\pard\nowidctlpar\nooverflow\sl240\slmult1{\f0\lang1033\fs24\kerning28 6-  Possible
 reasons and causes    The underlying cause seems to be almost certainly the number
 of times the stop pin was struck by the blade. The reasons for the number of strikes
 is harder to ascertain. Speaking with the director reveled that he had scheduled
 several different camera angles and to get all of them in it required several drops
 of the blade. His notes showed six [6] different shots and with a single exception
 all had to be reshot several times because in his words \u8220\'93 There was something
 that just didn\u8217\'92t look right with the shot.\u8217\'92 although just what
 that something was he was unable to explain at the time. When I examined the films
 later I noticed that one shot required eight [8] retakes and at first I could see
 what the director was referring to but I was also unable to decide just what was
 wrong. Using slow motion and stop frame it became clearer. Miss Ianure\u8217\'92
s facial expression and body language were wrong for a woman going to her death. 
She looked excited and in one shot I could see her pelvis moving in ways that suggested
 lovemaking. This would agree with the medical findings of sexual arousal I found
. It also agrees with some things I heard from friends about Miss Ianure\u8217\'92
s sexual proclivities. \par}

\pard\nowidctlpar\nooverflow\sl240\slmult1{\f0\lang1033\fs24\kerning28 7- Findings
    The death of Giselle Ianure was caused by beheading. Her death was an accident
 with no indication whatsoever of foul play. Proximate causes are 1] Poor design
 of the guillotine with special attention focused on the stop pin. 2] Failure to
 inspect the stop pin often enough to detect any early signs of failure. 3] A failure
 of anybody on the set to count the number of uses the pin had been subjected to
 and to realize that there was a possibility of failure. 4] The evidence suggests
 rather strongly that Miss Ianure was sexually aroused by the idea of being beheaded
 and that she let her sexual arousal interfere with her acting and with the filming
. This interference was perhaps a major if not the major reason for the extreme 
number of drops the pin was subjected to before the ultimate failure that lead to
 her decapitation and death. In short I believe that Miss Ianure caused her own 
death due to her intense arousal which necessitated the large number of drops which
 in turn led to the failure  of the stop pin. In short her sexual fantasies killed
 her.  \par}

\pard\nowidctlpar\nooverflow\sl240\slmult1{\f0\lang1033\fs24\kerning28                        
}}